Cold Fog - Atomizing Systems, IncAtomizing Systems Inc.

                                            Manufacturer of Cold Fog® Systems
Call: 888-COLDFOG                                        printer-friendlyprinter-friendly page  |  send this page forward this page  |   request free proposal  
ULManufacturer

About Basic Equipment

Typical Gas Turbine Inlet Air Cooling

Fog cooling system basically consists of fog nozzles installed on stainless steel arrays typically placed across the section of the gas turbine inlet air ducting before or after the air filter; high-pressure stainless steel head pumps supply water from 1000 to 3000 psi (70-200 bar); pre-filter unit at pump water inlet to block big particles (bigger than 1 micron) in water; distribution feed lines to nozzle arrays from pump; multi-zone valves enable water flow regulation; motor control with variable frequency drive (VFD) to vary pump flow output; weather station and down-stream temperature and humidity sensors to measure ambient conditions and after fogging cooler air conditions; PLC fog controller to determine water flow required based on inlet and out air conditions and gas turbine output.

Home | Fog Applications | ColdFog® Products | Fog Tech Center | Location and Directions | Legal Disclaimer
BROCHURES: Brochure IBM | Brochure CF3
Copyright © 1998-2012Atomizing Systems, Inc.*
One Hollywood Avenue, Ho-Ho-Kus, NJ 07423-1433, USA
Ph: 201.447.1222   F: 201.447.6932  Toll Free: 888.COLDFOG (265.3364)
E-mail: info@coldfog.com



website by powersolution.com
a Computer Network Technical Support, Managed Services Provide, Web Based Applications and Cloud Solutions IT Company in New Jersey
Copyright: © 1998-2012 Atomizing Systems, Inc., Ho-Ho-Kus, NJ.  All rights reserved.  The text, pictures, video files, audio files and artwork on the Atomizing Systems Inc website are all subject to copyright and other intellectual property protection.  The websites may also contain images to which copyright is attributable to third parties. Reproduction or transmission, in whole or in part, of any material contained within the site is prohibited without prior written permission of Atomizing Systems Inc.  Modification or redistribution of any material to third parties in any form or by any means is also forbidden.
Trademarks: Atomizing Systems Inc (logo or word) and the nozzle (device) are registered trademarks of Atomizing Systems Inc.  These trademarks cannot be used, modified, downloaded, copied or distributed in any way or by any means in the absence of the express prior written permission of Atomizing Systems Inc., 1 Hollywood Avenue, Ho-Ho-Kus, NJ 07423, USA, and in this case under the express condition that the authorization is clearly stated and/or is a part of an authorized download, copy or transmission or material from this website.